NEC Express5800/120Rg-1 User Manual

Also see for Express5800/120Rg-1: Datasheet User guide

Contents

NEC Express5800/120Rg-1 User Manual Manual pdf 160 page image

6-2 Installing and Using UtilitiesNEC EXPRESSBUILDERNEC EXPRESSBUILDER has some maintenance utilities and management software. NECEXPRESSBUILDER also helps you to install NOS (Windows Server 2003).NOTE: Before using NEC EXPRESSBUILDER for initial setup,complete the hardware configuration.NEC EXPRESSBUILDER has two executing modes depending on your operating environments.One is for using on Windows system, and the other is booted from NEC EXPRESSBUILDER CD. DOS-based with local consoleThe following menu appears on the local display after booting from NECEXPRESSBUILDER CD. You can install NOS or run the diagnostic program, and so on.NOTE: A mouse can't be used when EXPRESSBUILDER is operatedwith the remote KVM console. Use a keyboard. DOS-based with remote consoleUsed to set up the server from the management workstation by accessing the server overthe network or via serial port B.NOTE: The "CSL_LESS.CFG" file is required to run this program.Refer to " NEC EXPRESSBUILDER for DOS-based with RemoteConsole" described later in this chapter for detail.