4-22 Configuring Your Server RAID10 (spanning of RAID1)RAID10 is a RAID level combined with RAID0 and RAID1.Stores data on hard disk drives by dividing it (striping). Then, each striped data is writtenonto hard disk drives in mirroring mode. Owing to this feature, high disk accessperformance of RAID0 and, in addition, high reliability of RAID1 can be achieved.IMPORTANT: Logical capacity of the array is equal to one hard diskdrive connected.Installing the Hard Disk DrivesInstall the two or more SAS hard disk drives to your server. See Chapter 9 for detail.IMPORTANT: Use two hard disk drives of the same revolution. Inaddition, use two hard disk drives of the same capacity if you are goingto configure RAID1.Enabling RAID FeatureTo configure a hard disk drive as RAID drive, change the BIOS setting or the RAID configurationjumper switch on mother board.NOTE: The factory-set value is to use the hard disk drive as a singledisk drive.SATA Hard Disk Drive Model1. Run the BIOS SETUP utility described earlier in the chapter.2. Choose the Peripheral Configuration submenu in the Advanced menu.3. Change the options as follows.SATA Controller Mode Option: EnhancedSATA RAID: Enabled4. Save and exit the BIOS SETUP utility
