Configuring Your Server 4-27Menu Tree+: Selection/execution parameter : Setting parameter. •: Information display>: Can be set (modified) after creation of logical driveMenu Description+Configure Performs Configuration settings+Easy Configuration Set configuration (Using fixed value)+New Configuration Set new configuration+View/Add Configuration Additional setting / viewing configuration+Clear Configuration Clear configuration+Select Boot Drive Chose Bootable Logical Drive+Initialize Initialize logical drive+Objects Various settings+Adapter Set disk array controller+Sel. Adapter Clear configurationRebuild Rate 30Chk Const Rate 30FGI Rate 30BGI Rate 30Disk WC OffRead Ahead OnBios State EnableStop on Error NoFast Init EnableAuto Rebuild OnAuto Resume EnableDisk Coercion 1GBFactoty Default+Logical Drive Logical drive operation+Logical Drives Select logical drive (when multiple logical drives exist)+Initialize Initialize logical drive+Check Consistency Check logical drive redundancy+View/Update Parameters Display logical drive information• RAID Display RAID level• SIZE Display logical drive capacity• Stripe SIZE Display stripe size• #Stripes Display the number of hard disk drives in logical drive• State Display logical drive status• Spans• Disk WC Off: Write throughOn: Write back• Read Ahead+Physical Drive Physical drive operation+Physical Drive Selection Menu Select physical drive+Make HotSpare Set as hot-spare disk for auto rebuilding+Force Online Make a disk online+Force Offline Make a disk offline+Drive Properties Display hard disk drive information• Device Type Hard disk drive type• Capacity Hard disk drive capacity• Product ID Hard disk drive model• Revision No. Hard disk drive revision+Rebuild Perform rebuilding+Check Consistency Perform logical drive redundancy check