Troubleshooting 8-27When more than two Network adapter are specified, the detailed specification ofTCP/IP protocol are all set to use DHCP.→ When more than two Network adapter are specified, the detailed specification of theprotocol may all be set by default value. Re-specify the details from Control Panel.Not more than two Network adapter is connected, but the detailed specification ofthe protocol are all set by default.(e.g. Specified IP Address on TCP/IP, but DHCP isspecified)→ Are you specifying more than two protocols?In this case, the situation will be the same as connecting more than two Networkadapter, so the detailed specification of the protocol are all set by default.Re-specify the details from Control Panel after starting the OS.Problems with Master Control MenuThe master control menu fails to appear:T Is your system Windows NT 4.0 or later, or Windows 95 or later?→ The menu is only able to run on Windows NT 4.0 (or later) or Windows 95 (orlater).T Is Shift pressed?→ Setting the CD-ROM with Shift pressed down cancels the Autorun feature.T Is the system in the proper state?→ The menu may not appear depending on the system registry setting or the timingto set the CD-ROM. In such a case, start the Explorer and run \MC\1ST.EXE inthe CD-ROM.
