Configuring Your Server 4-11Peripheral ConfigurationIMPORTANT: Note that the interrupt and/or base I/O address are notoverlapped with others. If the value set for the interrupt or base I/Oaddress is used in another resource, the yellow asterisk (*) appears.Reset any item with the yellow asterisk properly.Option Parameter Description Your SettingSerial Port A Disabled[Enabled]Selects whether serial port A isenabled or disabled.Base I/O address [3F8]2F83E82E8Selects the base I/O address for serialport A.Interrupt IRQ 3[IRQ 4]Selects the interrupt for a serial port A.Serial Port B Disabled[Enabled]Selects whether serial port B isenabled or disabled (display only).Base I/O address 3F8[2F8]3E82E8Selects the base I/O address for serialport A.Interrupt [IRQ 3]IRQ 4Selects the interrupt for a serial port A.USB 2.0 Controller Disabled[Enabled]Selects the USB 2.0 controller isenabled or disabled.Parallel ATA Disabled[Enabled]Selects parallel ATA is enabled ordisabled.Serial ATA* Disabled[Enabled]Selects whether the serial ATA isenabled or disabled.SATA ControllerMode Option*[Compatible]EnhancedCompatible mode:SATA and PATA drives areautomatically detected andrecognized as legacy mode.Enhanced mode:SATA and PATA drives areautomatically detected andrecognized as native mode.SATA RAID* [Disabled]EnabledSelects whether the RAID disk drivesthat uses the onboard SATA isenabled or disabled.SATA AHCI [Disabled]EnabledSelect [Enabled] when SATA5 orSATA6 is used (Advanced HostController Interface).[ ]: Factory-set* Displayed only for the SATA hard disk drive model.
