605 BASIC SETTINGS5.1 NAMING YOUR SOURCESThe SDP-75 provides very flexible Source Configurations. Each Source Configuration can be renamed to reflect the actualsource to which is corresponds. By default, the source names correspond to the names of the back panel connectorsbut can be edited in the Home/Sources Config page of the Advanced Settings Interface.A Source Configuration can also include specific output and processing parameters. Therefore, it can be used to switchbetween outputs or between different processing settings. For example, it is possible to configure two SourceConfigurations set on the same inputs but set with different names to recall different settings.The Home/Source Config page consists of one vertical tab per source on the left and source-specific parameters onthe right.Figure 41: Source Configuration panelIMPORTANT NOTE: It is particularly important to define user friendly names for the first four sourcesbecause they are displayed on the front panel screen, and can be recalled from the front panel or fromthe IR remote control source selection buttons.Click on the sourcename to editClick on the Save buttonto save new settingsClick on the Reloadbutton to restore thepreviously savedsettingsClick on the Factorybutton to restore allsources to the factorydefault.
