JBL SDP-75 User Manual

Contents

NOTICES
important safety
Table Of Contents
Table Of Contents
Table Of Contents
Table Of Contents
INTRODUCTION
A BOUT THIS GUIDE
P RODUCT INFORMATION
S YSTEM INTEGRATION
U NPACKING THE SDP-75
T HE HARDWARE
Rear panel layout
IR remote control
T HE SOFTWARE
Important note about the web-based interface
The Top menu bar
Folded lateral menu
Unfolded lateral menu
The Speakers/Room setup tool
product information
software updates
NETWORK SETUP
C ONNECTING TO THE SDP-75
Step 1: download and install a VNC client on your device
Step 2: put the SDP-75 and your device on the same network
Step 3: connect to the SDP-75 from your device
Using a Mac OS X computer with Screen Sharing
Using a Mac OS X computer with Chicken of the VNC
Using a Windows computer with Tight VNC
Checking the Wi-Fi settings
C HANGING THE W I -F I SETTINGS THROUGH THE GUI
Changing the Wi-Fi Status mode of the SDP-75
About the Ethernet information
About VNC (Virtual Network Computing)
NETWORK STREAMING
RECOMMENDED UP N P SOFTWARE
DAILY OPERATIONS
U SING THE FRONT PANEL
Volume control
Checking the format of incoming audio
U SING THE IR REMOTE CONTROL
U SING THE GRAPHICAL INTERFACE
BASIC SETTINGS
C ONFIGURING YOUR SOURCES
D EFAULT SOURCE CONFIGURATION
L EVEL AND D ELAY A LIGNMENT OPTIONS
N AMING , SAVING AND LOADING PRESETS
D EFAULT PRESET
B ACKUP /R ESTORE OF PRESETS
ESSENTIAL TOOLS AND SETTINGS
M ETERING THE INPUTS AND OUTPUTS
P LAYING PINK NOISE ON THE SPEAKERS
V IEWING THE ACOUSTICAL GRAPHS
important notes
Choose display options according to your requirements
SPECIFY THE SPEAKER LAYOUT
A N EXAMPLE OF A SPECIFIC SPEAKER LAYOUT
A VAILABLE INITIAL LAYOUTS
S ELECT AN INITIAL SPEAKER LAYOUT
A DDING SPEAKERS
R EMOVING SPEAKERS
C ONFIGURE THE CROSSOVER SETTINGS ( OPTIONAL )
S AVE THE PRESET
SPECIFY AN ARRAY OF SPEAKERS
E XAMPLE OF AN ARRAY OF SPEAKERS
DECODER / UP-MIXER SETTINGS
L ISTENING F ORMATS
D ECODERS SETTINGS
Dolby decoder settings
DTS decoder Settings
Auro-3D decoder settings
VERY IMPORTANT TIPS
Requirements for the measurement environment
O VERVIEW OF THE CROSSOVER SETUP PROCEDURE
C ONFIGURE THE ADVANCED SETTINGS ( OPTIONAL )
A DJUST THE MASTER OUTPUT L EVEL
C ALIBRATE THE ACTIVE CROSSOVERS
V ERIFY THE SOUND OF THE CALIBRATED CROSSOVERS
A DJUST THE MASTER OUTPUT LEVEL
N ORMAL CALIBRATION SEQUENCE
C ALIBRATION STATUS
C HECKING THE SPEAKER SUMMARY AFTER CALIBRATION
M ULTI - POINT MEASUREMENTS ( OPTIONAL )
SETUP BASS MANAGEMENT
F ULLY CUSTOMIZABLE BASS MANAGEMENT
B ASS MANAGEMENT MODE
Q UICK SETUP MENU
LFE & MISC
Stacked Sub Correction
SETUP TARGET CURVES
VERIFY THE SOUND OF YOUR OPTIMIZED SPEAKER SYSTEM
L ISTEN TO THE SYSTEM
M AIN OPTIMIZATION SETTINGS
L IMITER CURVE
A DVANCED OPTIMIZATION SETTINGS
Optimize according to L&R speakers settings
Subwoofer low-pass filter settings
R ELEVANT MEASUREMENT POSITIONS
M ULTI - POINT CALIBRATION PROCEDURE
APPENDIX
S IGNAL FLOW OF THE SDP-75
DB25 C ONNECTOR : AES P INOUT
D MEASUREMENT MICROPHONE
Microphone specifications

JBL SDP-75 User Manual Manual pdf 129 page image

128Figure 94: Typical bass management in a standard surround preamplifier14.3 BASS MANAGEMENT MODEThe SDP-75 offers 3 different bass management modes:• Off: No bass management (default)• On: Standard bass management mode, which is recommended for all installations utilizing subwoofers.• On + LFE to LR: Distributes the LFE signal to the Left and Right speakers. Can be used when there is no subwooferin the system. Note that in this mode, if a subwoofer is declared, the LFE will not be played by this subwoofer. Thismode is rarely recommended.Those modes are accessible from dropdown menu as shown below: