105DTS DECODER SETTINGSFigure 71 : DTS:X Decoder Settings• Neural:X Up-mixer Bypass: Disables the Neural:X Up-mixer;• Direct Mode: In “Direct Mode,” the audio is extracted and reproduced as closely as possible to what thecontent creator intended. At a high-level, direct mode attempts to most closely preserve the original speakerlayout with no additional processing to take advantage of additional speakers;• UHD Enable: Allows rendering the 3D object. If this function is disabled, the decoder will play only on legacy(5.1/7.1) speakers;• DRC%: sets a percentage of Dynamic Range Control ;• Dialog norm: use the incoming metadata to adjust the level of the center channel;• LFE in stereo: send the LFE to a pair of subwoofers ;• Disable down-mix: Do not down-mix surround formats into stereo;• Audio description: switch on the visual description track intended for the blind and visually impaired ;• Channel remapping: This setting is only applicable for surround formatso None : No channel remapping is appliedo Auto: apply automatic channel remapping that matches the incoming channels to the speakersystem;o Auto on DTS configs: apply automatic channel remapping accordingly to some specifics speakersconfigurations determined by DTSo 2.0 – 7.1 settings: force playback on a specific speaker configuration such as 7.1 independentlyfrom the incoming channels;• Solo stream: enable the Primary or Secondary solo stream.• Interactive Object: If interactive objects are available on the content in use, a slider will provide a volumecontrol on these interactive objects. The slider is disabled if no interactive objects are available. Theinteractive objects are usually dialog objects, therefore you are able to adjust the dialog level.
