Honeywell LYNX Touch Series Installation And Setup Manual

Also see for LYNX Touch Series: User guide Guide Installation and setup guide Programming guide Quick installation guide

Contents

Honeywell LYNX Touch Series Installation And Setup Manual Manual pdf 54 page image

LYNX Touch Installation and Setup Guide- 54 -System Operation“Follow Me” System Announcement FeatureThis feature allows the LYNX Touch to deliver a voice system message to the user phone numbersprogrammed by the installer. The LYNX Touch will first transmit reports to the Central Station and afterreceiving its kiss-off the system will dial the user phone numbers and begin transmitting the welcomemessage “System Message, Press Star to Play”. The system will dial the user phone numbers a maximum ofeight times.The “Follow Me” System announcements feature is only supported if PSTN line is available. Theannouncements are individually sent to the phone, numbers which are programmed as Phone 1 and Phone 2respectively in the Reporter Programming section. System Follow Me announcements are triggered by asystem event that belongs to one of the Event Groups enabled by Installer individually for the programmedphone number(s). The groups are listed below.• All Bypassing actions by a user• Any Open/Close (arming/disarming status changes)• Any Alarms• Any Alarm Restores• Alarm Cancel by the user• Any System Troubles• Any Test• Non-security EventsIf a “*” key is not pressed, LYNX Touch will announce “System message Press * to Play” for 45 secondsbefore hanging up and redialing the programmed number. The control will make eight attempts beforeunsuccessfully ending the System “Follow Me” session and erasing all the events in the queue. The next callwill be triggered by a new event from the Event Group enabled for the programmed number(s).If a “*” key is pressed, LYNX Touch will play back a sequence of System “Follow Me” announcements fromthe queue in chronological order starting with the oldest one. The announcements will include “End ofMessage” at the end of the “Follow Me” announcements.If a “*” key is pressed again during playback or within 15 seconds following the end of the playback, thecontrol will repeat the sequence. Otherwise the system will hang up, successfully ending the System “FollowMe” session. Because the “*” key was pressed LYNX Touch will not redial the number again. The next callwill be triggered by a new event from the Event Group enabled for the programmed number(s).Note: The follow me system announcement will be terminated if any other event requires the system to send a report to theCentral Station. Once the PSTN line is available the session will be resumed and the control will again make up to 8delivery attempts.Follow Me Event Triggers Follow MeAnnouncement Follow Me Event Triggers Follow MeAnnouncementAC Loss AC Loss Interior Alarm Interior AlarmAudible Panic Panic Alarm Keypad Panic Panic AlarmAutomatic Disarmed Disarmed Manual Test System TestBattery Failed Under Load System Low Battery Medical Alarm Emergency AlarmBurglary Zone Bypass Zone ** Bypassed Perimeter Alarm Perimeter AlarmCarbon Monoxide Detected Carbon Monoxide Alarm Remote Disarm DisarmedDisarmed From AWAY or STAY Disarmed RF Sensor Lost System TroubleEmergency Alarm Emergency Alarm Sensor Low Battery or Tamper Sensor TroubleEntry/Exit Alarm Perimeter Alarm Silent Burglary Silent BurglaryExit Error Alarm (zone) Perimeter Alarm Siren Tamper Tamper AlarmExpansion Module Tamper Tamper Alarm System Inactivity No Check InExpansion Module Failure System Trouble System Low Battery System Low BatteryExpansion Module Tamper Alarm Tamper Alarm Water Leakage Alarm Auxiliary AlarmExpansion Module Tamper Trouble Tamper Alarm Zone Bypass Zone ** BypassedFire Alarm Fire Alarm Zone Tamper (Alarm) Tamper AlarmFire Trouble System Trouble Zone Trouble System Trouble** = Zone Number