Honeywell LYNX Touch Series Installation And Setup Manual

Also see for LYNX Touch Series: User guide Guide Installation and setup guide Programming guide Quick installation guide

Contents

Honeywell LYNX Touch Series Installation And Setup Manual Manual pdf 26 page image

LYNX Touch Installation and Setup Guide- 26 -Programming the ControlProgram the Communications ModuleA router is required if you are installing the L5100-WiFi module. The router must be powered on andconnected for WiFi operation (alarm reporting) to occur.The following system options are programmed in this section:Option FunctionCommunications Path Selects type of Communications ModuleAPL Enables Advanced Protection LogicCity ID Enter Central Station Primary City IDCS ID Enter Primary Central Station IDSub ID Enter Central Station Primary Subscriber IDSupervision Selects how often the Communications Module sends supervisory messages to the Central Sta.Old Alarm Time Selects how long an undeliverable alarm delivery is retried to the Central Station.Remote Acc. Comm. Enables or disables user remote access via internet and/or GSM.Multi Mode Comm. (appears only if Remote Access IP or GSM is enabled.) Enables or disables multi mode feature.IP Fault Time (Appears only if IP is enabled in Communications Path field.) Selects time delay before theCommunications Module notifies the control panel of a loss of contact with the internet.Use DHCP Dynamically selects the IP addressesNIC IP Address (Appears only if “No” is selected in Use DHCP field.) Enter NIC IP Address.Subnet Mask (Appears only if “No” is selected in Use DHCP field.) Enter Subnet Address.Gateway IP Address (Appears only if “No” is selected in Use DHCP field.) Enter Gateway IP AddressDNS Server IP Address (Appears only if “No” is selected in Use DHCP field.) Enter Domain Name Server IP Address.GSM Fault Time (Appears only if GSM is enabled in Communications Path field.) Selects time delay before theCommunications Module notifies the control panel of a loss of contact with the network.GSM Rollover Allows messages to be sent over GSM in the event that contact with the internet is lost. (Appears onlyif “WiFi & GSM” is selected as the Communications Path.)GSM 24 Hour Test Enables daily test of GSM module operation. (Appears only if “WiFi & GSM” is selected as theCommunications Path.)Note: If applicable, preprogrammed defaults for the LYNX Touch Control are shown on the screen unless otherwise noted.Remote Access (Total Connect) and Multi Mode (PSD) over IP or GSM cannot be enabled in the panel alone. Availability ofthis service is controlled via the web-based programming tool on the AlarmNet Direct website. These features must to beenabled through the AlarmNet Direct website first and transferred to the device.SCREEN ACTION5000-100-132-V0CommunicatorCommunicator1. Select “Communicator”. The System displays several pages of options that varydepending upon the selections that are made. Use the down T arrow to scrollthrough the pages of options.Communications Path APLCity ID CS ID Sub IDSupervision Old Alarm TimeRemote Acc. Comm. Multi Mode Comm.IP Fault Time Use DHCPGSM Fault TimeCommunications PathNone2. Select “Communications Path”. The system scrolls between the following options.Notes: The available options are dependant upon which communications module(s) areinstalled. If Communication Path is set to GSM, the L5100 will report to AlarmNetover GSM/GPRS not WiFi.None WiFiIP WiFi & GSMGSMAPLDisabled3. Select “APL”. The system scrolls between “Enabled” and “Disabled”.Note: If APL is used, GSM or IP must be selected as the Primary Communicator Type in theReporter programming.City ID 4. Select “City ID”. Enter the 2-digit Primary City ID (Decimal).Options01-99CS ID 5. Select “CS ID”. Enter the 2-digit Primary Central Station ID (HEX).Options01-FE