Honeywell LYNX Touch Series Installation And Setup Manual

Also see for LYNX Touch Series: User guide Guide Installation and setup guide Programming guide Quick installation guide

Contents

Honeywell LYNX Touch Series Installation And Setup Manual Manual pdf 23 page image

LYNX Touch Installation and Setup Guide- 23 -Programming the ControlSystem TypeThe following system options are programmed in this section:Option FunctionRF Jam Enable or disable RF Jam Log and ReportingSpeaker Phone Enable or disable Speaker Phone mode. (End User feature)Two Way Voice Enable or disable Two Way Voice communication with the Central Station.RF House Code Set RF House Code. (Bi-directional RF Devices)Phone Notification Enable or disable Phone Notification mode. (Phone Line-cut)Phone Detect Time Select a delay period between phone line-cut & system response (allows phone to restore)Note: This field is displayed if Phone Notification is enabled.Remote Phone Enable or disable Remote Phone Control mode. (End User feature)Events Enable or disable multiple options for event logging (i.e.; alarms, troubles, open/close, bypass, all)Non-Security Enable or disable non-security event loggingRemote AccessSerialEnable or disable end user to access their system via a websiteMulti Mode Serial Enable or disable transmission of panel status events via email (Active only when Remote AccessSerial is enabled)Note: If applicable, preprogrammed defaults for the LYNX Touch Control are shown on the screen unlessotherwise noted.Screen ACTION5000-100-130-V0System Type System TypeNote: If applicable, the pre-programmed default will be displayed beneath the option.1. Select “System Type” from the following options:RF Jam Speaker PhoneTwo Way Voice RF House CodePhone Notification Remote PhonePhone Detect TimeUse the down T arrow to scroll to the next page of options.Events – Log All Events – Log AlarmEvents – Log Bypass Events – Log Open/CloseEvents – Log Trouble Non SecurityRemote Access Serial Multi Mode SerialRF JamDisabled2. Select “RF Jam”. The System scrolls between the following:DisabledRF Jam LogRF Jam Log & ReportSpeaker PhoneEnabled3. Select “Speaker Phone”. The System toggles between the following:DisabledEnabledTwo Way VoiceDisabled4. Select “Two-Way Voice” .The System toggles between the following:DisabledEnabledRF House Code05. Select “RF House Code”.6. After entering a code (00-31) on the displayed keypad, select “Done”.Phone NotificationDisabled7. Select “Phone Notification” (phone line cut). The System scrolls between the followingoptions:DisabledKeypadTroubleIf “Keypad” or “Trouble is selected proceed to Step 8.