Honeywell LYNX Touch Series Installation And Setup Manual

Also see for LYNX Touch Series: User guide Guide Installation and setup guide Programming guide Quick installation guide

Contents

Honeywell LYNX Touch Series Installation And Setup Manual Manual pdf 53 page image

LYNX Touch Installation and Setup Guide- 53 -System OperationSecondary User CodesIn normal operation mode, the Master Security Code can be used to assign up to 14 secondary 4-digitsecurity codes, including a Babysitter Code and a Duress Code. The Master Code can also be used to removesecondary codes from the system (individually). Refer to the LYNX Touch User Manual for additionalinformation.Reset Master User Code1. After Entering the Installer Programming Mode, select “Reset Master Code” from the second page of theInstaller Programming Tools menu.2. The system displays a confirmation screen. Select the “Yes” key to reset the Master User Code to “1234”.3. If confirmed, the Master Code will be reset back to “1-2-3-4”. This will be logged in the System Event Logas “Reset Master Code User 2 E655”. The system returns to the second page of the InstallerProgramming Tools menu. ORIf the reset failed, the system will display: “Command Failed. Unable to Reset Master Code”.Security Code Notes• The Master and Secondary security codes permit access to the system for arming, disarming, etc.• The Installer Code can disarm the system only if it was used to arm it. In addition, the Installer Code cannotdisarm the system if it was armed by pressing and holding a Quick-Arm button.• The Babysitter Code can disarm the system only if it was used to arm it. In addition, the Babysitter Code cannotdisarm the system if it was armed by pressing and holding a Quick-Arm button.• Duress code sends a special code to the monitoring station when used to perform any system operation. Instructusers to be careful not to use this code for normal usage.• Opening/closing reports are sent for the Installer Code, with the appropriate subscriber number. Master Code andset of secondary user codes are sent as Nos. 02 and 03–14, respectively, in Contact ID® format (with theappropriate user number).