Honeywell LYNX Touch Series Installation And Setup Manual

Also see for LYNX Touch Series: User guide Guide Installation and setup guide Programming guide Quick installation guide

Contents

Honeywell LYNX Touch Series Installation And Setup Manual Manual pdf 43 page image

LYNX Touch Installation and Setup Guide- 43 -Programming the ControlCommunications DiagnosticsCommunications Status – The system provides a status of the IP or GSM communications paths andperforms a self-test of the AES encryption algorithm as follows:Message MeaningGSM: OK Normal; No fault. (IP or GSM)OR Fault Reported! No network connectivity and fault time has expired. (IP or GSM)IP: Not Connected No network connectivity over IP and fault time has NOT yet expired.Not Registered! No network connectivity over GSM and fault time has NOT yet expired.No Physical Link No network connectivity over IP and fault time is set to 0.Encryption: AES Passed! Test successful.AES Failed! Test failed.No Encryption! No encryption algorithm set.Alarmnet Registration: Registered Communication Device is Registered with AlarmNet.Not Registered Communication Device is not Registered with AlarmNet.Ethernet Information – Displays IP information, if IP communication path is enabled.Physical Link: Indicates status of the physical connection to the internet.DHCP: DHCP (Dynamic Host Configuration Protocol) indicated server is performing satisfactorily.NIC IP Address: Displays the IP address assigned to this deviceSubnet Mask: Displays the 32-bit address mask used to indicate the portion (bits) of the IP address that is beingused for the subnet address.Gateway IP Address: Displays the IP address assigned to the Gateway.DNS Server IP Address: Displays the IP address assigned to the DNS (Domain Name System) server.Message MeaningPhysical Link 10 Mbps or 100 Mbps Link speed of physical connectionBad No physical connectionDHCP OK DHCP address resolvedBad DHCP address not resolvedOff DHCP disabledGSM Information – Displays GSM information if GSM communication path is enabled.Status Message MeaningGSM Registered Cell Registration: Home 2G Registered Home with 2G ServiceHome 3G Registered Home with 3G/4G ServiceRoaming Registered RoamingPrimary RSSI: (See RSSINote below)Primary Site RSSI level signal strength(1 to 5 stars or “Not Present” will be displayed)GPRS: (2G Only) Yes GPRS Service availability(Always available in 3G/4G) No GPRS is not availableCountry: xxx Country CodeNetwork: xxx Network CodeLAC xxxxx Local Area CodeCell: (2G only) xxxx Base Station IDCell: (3G/4G only) xxxxxx Base Station IDBase Station: (2G Only) xx Base Station Antenna SectorPrimary Sync Code (3G/4G Only) xxx Primary Sync CodeChannel: xxxx Control Channel in useSecond Site RSSI: (See RSSINote below)Secondary Site RSSI level availability(“Present” OR “Not Present” will be displayed)GSM Not Registered Searching For Coverage! Searching for cell network.SIM Error! No SIM card present or SIM card faultyCell Registration: SIM Not Active SIM is not activatedCell Registration: Not Registered Not registered with cell networkRSSI Note: Primary Site Signal strength is displayed by a series of 1 to 5 stars (* weak to ***** strong) or “Not Present” if there is nosignal. To ensure a reliable installation at least 2 (**) stars should consistently be present. Secondary site presence isindicated by “Present” or “Not Present”.