Honeywell LYNX Touch Series Installation And Setup Manual

Also see for LYNX Touch Series: User guide Guide Installation and setup guide Programming guide Quick installation guide

Contents

Honeywell LYNX Touch Series Installation And Setup Manual Manual pdf 11 page image

LYNX Touch Installation and Setup Guide- 11 -Installing/Configuring Communication & Home Automation ModulesInstalling the ILP5 Ethernet Communications Module!Do not install the ILP5 if the L5100-WiFi communications module is being installed.Ensure that the connector board and cable are securely installed in the ILP5 before installing thecommunications module in the LYNX Touch.1. Using a wire cutter or knife cut the plastic tabs that secure the ILP5 spacer to the back case of the LYNX Touch.2. Remove the ILP5 receptacle knockout from the left side of the LYNX Touch back case.3. Install the ILP5 into the LYNX Touch control front case. Ensure that the connector board is properly seated into the receptacle on thecontrol.4. Secure the ILP5 with the three provided screws.5. Insert the ILP5 receptacle and spacer into the slot on the back case.6. Secure the communications cable to the tie wrap point on the ILP5 with the provided tie wrap.7. Connect the Ethernet cable to the RJ45 receptacle.8. Enable the ILP5 and configure alarm reporting and module supervision and register the device. Refer to the “Program theCommunications Module” and “Communications Diagnostics” sections.Alternate Installation (Refer to the Alternate Installation as shown on the figure below)1. Install the ILP5 into the LYNX Touch control front case. Ensure that the connector board is properly seated into the receptacle on thecontrol.2. Secure the ILP5 with the three provided screws.3. Insert the ILP5 receptacle into the slot on the back case as shown on the figure below.4. Secure the communications cable to the tie wrap point on the ILP5 with the provided tie wrap.5. Connect the Ethernet cable to the RJ45 receptacle.6. Enable the ILP5 and configure alarm reporting and module supervision and register the device. Refer to the “Program theCommunications Module” and “Communications “Diagnostics” sections.The communications module must be registered with AlarmNet before downloading or alarm reportingcan take place.SCREW(3)5100-100-065-V0ROTATED180CONNECTORBOARDCONNECTOR BOARDRECEPTACLEILP5LYNX TOUCHTIEWRAPPOINTREMOVE ILP5SPACERILP5 SPACERREMOVE ILP5KNOCKOUTTIEWRAP(1)TO ILP5LYNX TOUCHALTERNATE INSTALLATIONRJ45RECEPTACLERJ45 RECEPTACLEETHERNET CABLE