H3C S5100-SI Operation Manual

Also see for H3C S5100-EI: Operation manual Installation manual Quick start

Contents

H3C S5100-SI Operation Manual Manual pdf 824 page image

1-3z Disable the PCs that are not of Organization 1 (PC 2 and PC 3) from accessing the externalnetwork through GigabitEthernet 1/0/1 of Switch A.Network diagramFigure 1-2 Network diagram for access management configurationConfiguration procedurePerform the following configuration on Switch A.# Enable access management. system-view[Sysname] am enable# Set the IP address of VLAN-interface 1 to 202.10.20.200/24.[Sysname] interface Vlan-interface 1[Sysname-Vlan-interface1] ip address 202.10.20.200 24[Sysname-Vlan-interface1] quit# Configure the access management IP address pool on GigabitEthernet 1/0/1.[Sysname] interface GigabitEthernet 1/0/1[Sysname-GigabitEthernet1/0/1] am ip-pool 202.10.20.1 20Combining Access Management with Port IsolationNetwork requirementsClient PCs are connected to the external network through Switch A (an Ethernet switch). The IPaddresses of the PCs of Organization 1 are in the range 202.10.20.1/24 to 202.10.20.20/24, and thoseof the PCs in Organization 2 are in the range 202.10.20.25/24 to 202.10.20.50/24 and the range202.10.20.55 to 202.10.20.65/24.z Allow the PCs of Organization 1 to access the external network through GigabitEthernet 1/0/1 ofSwitch A.