2-9To do… Use the command… RemarksEnter system view system-view —Enter AUX user interfaceview user-interface aux 0 —Configure to authenticateusers using the localpasswordauthentication-modepasswordRequiredBy default, users logging in to a switchthrough the console port are notauthenticated; while those logging inthrough Modems or Telnet areauthenticated.Set the local passwordset authenticationpassword { cipher |simple } passwordRequiredConfiguration ExampleNetwork requirementsAssume the switch is configured to allow users to log in through Telnet, and the user level is set tothe administrator level (level 3). Perform the following configurations for users logging in throughthe console port (AUX user interface).z Authenticate the users using passwords.z Set the local password to 123456 (in plain text).z The commands of level 2 are available to the users.z The baud rate of the console port is 19,200 bps.z The screen can contain up to 30 lines.z The history command buffer can store up to 20 commands.z The timeout time of the AUX user interface is 6 minutes.Network diagramConfiguration PCrunning TelnetEthernetGE1/0/1Figure 2-7 Network diagram for AUX user interface configuration (with the authentication mode beingpassword)Configuration procedure# Enter system view. system-view
