1-19To do... Use the command... RemarksSet the client versionchecking period timerdot1x timer ver-periodver-period-valueOptionalBy default, the timer is set to30 seconds.As for the dot1x version-user command, if you execute it in system view withoutspecifying the interface-list argument, the command applies to all ports. You can alsoexecute this command in port view. In this case, this command applies to the current portonly and the interface-list argument is not needed.Enabling DHCP-triggered AuthenticationAfter performing the following configuration, 802.1x allows running DHCP on access users,and users are authenticated when they apply for dynamic IP addresses through DHCP.Follow these steps to enable DHCP-triggered authentication:To do... Use the command... RemarksEnter system view system-view —Enable DHCP-triggeredauthentication dot1x dhcp-launchRequiredBy default, DHCP-triggeredauthentication is disabled.Configuring Guest VLANFollow these steps to configure guest VLAN:To do... Use the command... RemarksEnter system view system-view —Configure port accessmethoddot1x port-methodportbasedRequiredThe default port accessmethod isMAC-address-based. Thatis, the macbased keywordis used by default.In systemviewdot1x guest-vlan vlan-id[ interface interface-list ]interface interface-typeinterface-numberdot1x guest-vlan vlan-idEnable theguest VLANfunction In port viewquitRequiredBy default, the guest VLANfunction is disabled.
