1-28Index Response Status LastRC Time1 4 1 0 2000-04-02 08:26:02.92 5 1 0 2000-04-02 08:26:02.83 4 1 0 2000-04-02 08:26:02.84 5 1 0 2000-04-02 08:26:02.75 4 1 0 2000-04-02 08:26:02.76 5 1 0 2000-04-02 08:26:02.67 6 1 0 2000-04-02 08:26:02.68 7 1 0 2000-04-02 08:26:02.59 5 1 0 2000-04-02 08:26:02.510 7 1 0 2000-04-02 08:26:02.4For detailed output description, see the corresponding command manual.UDP Test (Udpprivate Test) on the Specified PortsNetwork requirementsBoth the HWPing client and the HWPing server are H3C S5100-SI/EI series Ethernet switches. Performa HWPing Udpprivate test on the specified ports between the two switches to test the RTT of UDPpackets between this end (HWPing client) and the specified destination end (HWPing server).Network diagramFigure 1-9 Network diagram for the Udpprivate testConfiguration procedurez Configure HWPing Server (Switch B):# Enable the HWPing server and configure the IP address and port to listen on. system-view[Sysname] hwping-server enable[Sysname] hwping-server udpecho 10.2.2.2 8000z Configure HWPing Client (Switch A):# Enable the HWPing client. system-view[Sysname] hwping-agent enable# Create a HWPing test group, setting the administrator name to administrator and test tag toudpprivate.[Sysname] Hwping administrator udpprivate# Configure the test type as udpprivate.[Sysname-hwping-administrator-udpprivate] test-type udpprivate# Configure the IP address of the HWPing server as 10.2.2.2.
