1-35To do… Use the command… RemarksEnter Ethernet portviewinterface interface-typeinterface-number —Configure VLANmappingtraffic-remark-vlanidinbound acl-rule remark-vlanvlan-id [ all-packet |tagged-packet |untagged-packet ]RequiredBy default, VLAN mapping isnot configured.The S5100-EI series switchesdo not support the all-packetkeyword or the tagged-packetkeyword.Configuration example# Configure VLAN mapping to change VLAN IDs of all the incoming packets from networksegment 10.1.1.0/24 into 1001 on GigabitEthernet 1/0/1 (assume that GigabitEthernet1/0/1 carries VLAN 2 and is connected to network segment 10.1.1.0/24). system-view[Sysname] acl number 2000[Sysname-acl-basic-2000] rule permit source 10.1.1.0 0.0.0.255[Sysname-acl-basic-2000] quit[Sysname] interface GigabitEthernet 1/0/1[Sysname-GigabitEthernet1/0/1] traffic-remark-vlanid inbound ip-group 2000remark-vlan 1001Configuring Queue SchedulingRefer to Queue Scheduling for information about queue scheduling.Configuration prerequisitesThe queue scheduling algorithm to be used and the related parameters have beendetermined.Configuration procedures1) Configuring SP queuingFollow these steps to configure SP queuing:To do… Use the command… RemarksEnter system view system-view —For S5100-EI series switches:undo queue-scheduler [ queue-id ]&<1-8>Configure SPqueuing For S5100-SI series switches:undo queue-scheduler [ queue-id ]&<1-4>OptionalBy default, SPqueuing is used on allthe output queues ofa port.
