2-3Configuration procedureFollow these steps to configure a QoS profile:To do… Use the command… RemarksEnter system view system-view —Create a QoS profileand enter QoS profileviewqos-profile profile-nameRequiredIf the specified QoSprofile already exists, youenter the QoS profile viewdirectly.Configure trafficpolicingtraffic-limit inbound acl-ruletarget-rate [ conformcon-action ] [ exceedexceed-action ][ meter-statistic ]OptionalConfigure the packetfiltering action packet-filter inbound acl-ruleOptionalRefer to the ACL moduleof this manual forinformation about packetfiltering.Configure the prioritymarking actiontraffic-priority inbound acl-rule{ dscp dscp-value | coscos-value }OptionalApplying a QoS ProfileYou can enable a QoS profile to be dynamically applied or apply it manually.Configuration prerequisitesz To enable a QoS profile to be applied dynamically, make sure 802.1x has been enabledboth globally and on the port, and the authentication mode has been determined. Forinformation about 802.1x, refer to the 802.1x and System Guard module of this manual.z To apply a QoS profile manually, make sure the port to which the QoS profile is to beapplied has been determined.z The QoS profile to be applied has been determined.Configuration procedureFollow these steps to apply a QoS profile dynamically:To do… Use the command… RemarksEnter system view system-view —Enter Ethernet port view interface interface-typeinterface-number —
