1-32To do… Use the command… RemarksConfigure line rate line-rate { inbound |outbound } target-rateRequiredDisabled by default.Configuration example# Configure line rate for the incoming packets on GigabitEthernet 1/0/1, with the rate limitbeing 1024 kbps. system-view[Sysname] interface GigabitEthernet 1/0/1[Sysname-GigabitEthernet1/0/1] line-rate inbound 1024Configuring Traffic RedirectingRefer to Traffic Redirecting for information about traffic redirecting.This feature is available only on the H3C S5100-EI series switches.Configuration prerequisitesz The ACL rules used for traffic classification have been defined. Refer to the ACLmodule of this manual for information about defining ACL rules.z The port that the ACL matching packets are to be redirected to has been determined.Configuration proceduresYou can configure traffic redirecting for incoming packets globally, in a VLAN, in a portgroup, or on a port.1) Configuring traffic redirecting globallyFollow these steps to configure traffic redirecting for incoming packets globally:To do… Use the command… RemarksEnter system view system-view —Configure trafficredirectingtraffic-redirect inbound acl-ruleinterface interface-typeinterface-numberRequired2) Configuring traffic redirecting for a VLANFollow these steps to configure traffic redirecting for incoming packets in a VLAN:
