83Recording AudioMenusTable of Contents IndexLow Cut Filter (External Microphone)When you are recording using a microphone connected to the MICterminal, you can activate the low cut filter to reduce the sound of blowingwind, a car’s engine and similar ambient sounds.1 Make sure the input of the MIC terminal is set to[ß Microphone] (A 83).2 Press the MENU button.3 Open the [MIC Low Cut] submenu.[¡ Audio Setup] > [2] > [MIC Low Cut]4 Select the desired option and then touch [X].Switching the InputYou can select the input signal used by the MIC terminal depending onwhether you are using an external microphone or an external audiosource, such as an audio player.1 Press the MENU button.2 Open the [MIC Terminal Input] submenu.[¡ Audio Setup] > [2] > [MIC Terminal Input]3 Touch [Þ External Audio] or [ß Microphone] and thentouch [X].Audio LimiterThe audio limiter will limit the amplitude of audio signals to prevent audiodistortions when sudden, loud sounds are picked up by the camcorder.Start the procedure from step 1 for the built-in microphone and step 2 foran external audio source.1 Make sure ‘ [Audio Scene] is set to [„ Custom Setting](A 78).2 Make sure [Mic Level] is set to [ ] (A 79).3 Press the MENU button.4 Open the [Audio Limiter] submenu.[¡ Audio Setup] > [2] > [Audio Limiter]5 Touch [i On] and then touch [X].[¡ Audio Setup][2][MIC Low Cut][j Off][¡ Audio Setup][2][MIC Terminal Input][ß Microphone][¡ Audio Setup][2][Audio Limiter][i On]
