35Using the Remote ControllerMenusTable of Contents IndexUsing the Remote ControllerThe camcorder can be operated remotely. You can use the supplied remote controller as described in thissection. You can also use the camcorder’s network functions and wirelessly connect a compatible device tocontrol the camcorder. For details about wirelessly controlling the camcorder, refer toBrowser Remote:Controlling the Camcorder from a Network Device (A 125).Inserting the BatteryInsert the supplied lithium button battery into the remote controller beforeuse.1 Press the tab in the direction of the arrow () and pull out the batteryholder ().2 Place the lithium button battery with the + side facing up ().3 Insert the battery holder ().Activating the Remote Sensor1 Press the MENU button.2 Open the [Wireless Remote Control] submenu.[ System Setup] > [2] (in mode) or [1] (in mode) >[Wireless Remote Control]3 Select [i On] and then touch [X].Using the Remote Controller to Operate theCamcorderWhen using the remote controller, point it at the camcorder’sremote sensor.• The position of the delay switch on the remote controllerdetermines how the remote controller operates. Refer tothe following table.Operating modes:Delay switchposition mode mode2 Starts and stopsrecording a video clip.Takes a photo after a2-second delay.‹Takes a photo, evenwhile recording videoclip.Takes a photoimmediately.[ System Setup][2] (in mode) or[1] (in mode)[Wireless Remote Control][j Off ]Remote sensorDelay switch (bottom sideof remote controller)
