77User BitMenusTable of Contents IndexUser BitThe user bit display can be selected from the date or the time of recording, or an identification code consisting of8 characters in the hexadecimal system. There are sixteen possible characters: the numbers 0 to 9 and theletters A to F.In addition to being recorded with clips, the user bit information can be output along with the video signal outputfrom the HDMI OUT terminal.Setting the User Bit1 Press the MENU button.2 Open the [User Bit Type] submenu.[3 Recording Setup] > [2] > [User Bit Type]3 Select the desired option.• Select [ Setting] to set your own identification code, [ Time]to use the time as user bit, or [ Date] to use the date as the userbit.• If you selected [ Time] or [ Date], touch [X]. You do not needto perform the rest of the procedure. If you selected [ Setting], continue the procedure to set theidentification code.4 Touch [Í] or [Î] to set the first character and then touch the next field to set the next digit.• Change the rest of the characters in the same way.• Touch [Cancel] to close the screen without setting the user bit.5 Touch [OK] and then touch [X].User Bit OutputThe user bit is output from the HDMI OUT terminal in the selected type. When the frame rate set in[3 Recording Setup] > [1] > [4K Recording] or [HD Recording] is 23.98P and [3 Recording Setup] > [1]> [User Bit Output Mode] is set to [ Pulldown], the user bit will contain 2:3 pulldown data.Operating modes:[3 Recording Setup][2][User Bit Type][ Setting]
