5–13INSTALLATIONCOPYRIGHT © 1998 CANON INC. CANON NP6621 REV.0 FEB. 1998 PRINTED IN JAPAN (IMPRIME AU JAPON)RemarksTo enter settings,• Select ‘No. 313’ in service mode, and enter the settingrecorded on the label (PRIMARY) using the keypad. (Toenter ‘–’, press the % key before entering the setting.)Then, press the Start key to store the setting.To enter the setting for IP_OFST, select ‘No. 314’ inservice mode and work in the same way.The copier automatically sets the APVC value; it stops inabout 23 sec.Follow image adjustment procedure.(See the Service Handbook P.1-5.)Step89101112131415WorkTurn on the door switch using thedoor switch actuator; then, shift thepower switch to ‘ON’.Only the European model, in caseof the other model, go to next step.Select service mode No. 313/314,and enter the settings recorded onthe drum label.To select service mode,• Press the service mode switch(SW850) with a hex key.Select ‘3’ of the mode by press-ing ‘3’ on the keypad and AEkey; then, select ‘No. 3 xx’ bypressing ‘x’ and ‘x’ on the keypadand the Start key.Turn off the power, and open thecopier’s top unit.Replace the static eliminator, andclose the copier's top unit.Close the front door, and turn onthe power.Only the European model, in caseof the other model, go to next step.Execute ‘No. 412’ in service mode.• Press the service mode swicth(SW850), ‘4’ on the keypad, AEkey, ‘1’ and ‘2’ on the keypad,and Start key in sequence.Remove the door switch actuator,and close the front door.Place the test sheet and checkcopy.Service mode switch
