Specifying print format parametersUsing LCDS Print Description Language 4-73What to do:In order to run the job in succession, you must code the JSLwith MOD=5 and POS=1 for Job 1 and MOD=5 and POS=5for Job 2. The system keeps track of the last tab position intray 2 at the end of Job 1. Upon starting Job 2, printer purgesTab 3 and Tab 4 because Job 2 starts with POS=5 and Job 1used Tab 1 and Tab 2.• You can improve performance by ordering applicationdependent tab stock. Using ordered tab stock that supportsonly the number of tabs required for a specific job eliminatesthe need for purging unused tabs.OUTPUT PAPERSIZESpecifies the size of paper that will be used for printing the job.Syntax OUTPUT PAPERSIZE = {A3 | A4 | B4 | B5 | USLEGAL |USLETTER | (x, y)}OptionsDefault System default size that was specified at installationOUTPUTPAPERSIZEparameter: pointsto note• When centimeters (CM) are used to specify paper size, themaximum allowable value is 32,767 cm.• Paper size cannot be changed by a DJDE on a page basis.However, paper sizes can be changed on a report basis.Table 4-68. OUTPUT PAPERSIZE parameter options and definitionsOption DefinitionA3 16.54 by 11.69 inches / 297 by 420 mmA4 8.27 by 11.69 inches / 287 by 270 mmB4 10.12 by 14.33 inches / 257 by 364 mmB5 7.17 by 10.12 inches / 178 by 254 mm (with the 7 by 10 inch enablement kit)USLEGAL 8.5 by 14 inches / 216 by 356 mmUSLETTER 8.5 by 11 inches / 216 by 279 mm(x, y) A user defined paper size; that is, a size that is not one of the standard sizes.The x and y variables define the width and length of the nonstandard stock;e.g., 7,10 for 7 by 10 inches.
