Xerox DocuPrint 100 Software Manual

Also see for Docuprint 75: Getting started Software guide Planning guide Supplementary guide Operator's guide

Contents

Xerox DocuPrint 100 Software Manual Manual pdf 177 page image

Specifying input parametersUsing LCDS Print Description Language 2-69OptionsDefault EBCDICVOLUME UNPACKSpecifies the unpacking method of the input data whenunpacking is required.Syntax VOLUME UNPACK = {NONE | T4X3 | T4X3H2 | UNIVAC}OptionsDefault NONETable 2-77. VOLUME TCODE parameter options and definitionsOption Definitiontcode Type Specifies one of the following standard character sets for which typeassignments are defined by default:• ASCII• BCD• EBCDIC• H2BCD• H6BCD• IBMCD• PEBCDICBy coding any one of the keywords, you are furnished with a set of character totype assignments.label Specifies an identified label of a TCODE parameter that defines a set of typeassignments.Table 2-78. VOLUME UNPACK parameter options and definitionsOption DefinitionNONE Does not perform the unpacking operation.T4X3 orT4X3H2Specifies unpacking routines in which 6-bit characters are extracted andrestored as 8-bit bytes.UNIVAC Specifies an unpacking routine used for UNIVAC tapes, although you canspecify any of these routines independent of the HOST type.