Xerox DocuPrint 100 Software Manual

Also see for Docuprint 75: Getting started Software guide Planning guide Supplementary guide Operator's guide

Contents

Xerox DocuPrint 100 Software Manual Manual pdf 174 page image

Specifying input parameters2-66 Using LCDS Print Description LanguageOptionsDefault 80VOLUME OPTIMIZEEnhances the performance of the data stream.NOTE: This parameter is supported only partially by the DPEPS. The parameter options table below reflects only the optionsthat are supported.Syntax VOLUME OPTIMIZE = {NCCHECK | NONE}OptionsVOLUMEOPTIMIZEparameter: Pointto noteThe NCCHECK option is supported for DP EPS only for FujiXerox markets. It is processed in other markets as if NONE werespecified.Table 2-71. VOLUME MINLAB parameter options and definitionsOption Definitionvalue Specifies in bytes the maximum length of the smallest physical block. The valuecan range from 1 to 4095 bytes. The specified value must be less than theMAXLAB value and must not exceed the BLOCK LENGTH.Table 2-72. VOLUME OPTIMIZE parameter options and definitionsOption DefinitionNCCHECK NCCHECKDisables channel 9 and channel 12 detection. When this option is selected. thehost is not notified by the printing system each time channel 9 or 12 isrecognized. Any skips to channel 9 or 12 are allowed as for any other channel.NOTE: This option is supported on the DP EPS only for Fuji Xerox markets. Allother DP systems process it as NONE.NONE No optimization actions are taken.