Specifying print format parameters4-24 Using LCDS Print Description LanguageOptionsDefault LARGE[ST]LINE BASELINEparameter: pointto noteIf KANJI is specified as one of the fonts (KANJI = YES), aBASELINE=LARGE command is treated as BASELINE=TOP.LINE BLANKTYPESpecifies whether or not the “shift in” and “shift out” functioncodes are printed as spaces.Syntax LINE BLANKTYPE = {F | V | SPACE | NOSPACE}OptionsDefault NOSPACETable 4-25. LINE BASELINE parameter options and definitionsOption DefinitionTOP Determines the baseline position from the top of each line by using theBASELINE parameter of the first font in the PDE font list.CENTER Positions all of the characters so that their center lines match.BOTTOM Determines the baseline from the bottom of each line by using theBASELINE parameter of the first font in the PDE font list.LARGE[ST] Determines the baseline position and the line spacing by using the largestfont in the PDE font list.Table 4-26. LINE BLANKTYPE parameter options and definitionsOption DefinitionF Specifies the width of the back space character that is associated with thewidth of the full-sized single-byte character, or of the half-sized double-bytecharacter.V Specifies the width of the back space character that is associated with the full-sized single-byte or double-byte character.SPACE Replaces X’0E’ and X’0F’ (“shift-in” and “shift-out”) function codes with single-byte blank character spaces.NOSPACE Specifies that no space code is substituted.
