21.5 Configure the network settings of the camerausing the Panasonic “IP Setting Software”It is possible to perform the network settings of the camera using the “IP Setting Software” on the providedCD-ROM. When using multiple cameras, it is necessary to configure the network settings of each cameraindependently. If the Panasonic “IP Setting Software” does not work, configure the network settings of thecamera and the PC individually on the “Network” page of the setup menu. (®page 166)IMPORTANT• When using Windows 7 or Windows Vista, the “Windows Security Alert” window may be displayedwhen starting the “IP Setting Software”. In this case, disable “User Account Control” from the controlpanel.• Panasonic “IP Setting Software” is inoperable in other subnets via the same router.• This camera cannot be displayed or set with an older version of the “IP Setting Software” (version 2.xx).SW396SW396SW395SW395SC386SC386SC385SC385SC384SC384:• For the security enhancement, the MAC address/IP address of the camera to be configured will not bedisplayed when around 20 minutes have passed after turning on the power of the camera. (When theeffective period is set to “20min” in the IP setup.)However cameras in the initial set mode are still displayed even after 20 minutes.SW175SW175SW174WSW174WSW172SW172ST165ST165ST162ST162:• For the security enhancement, the “Network Settings” will not be able to be performed when around20 minutes have passed after turning on the power of the camera. (When the effective period is set to“20min” in the IP setup.)1. To start the Panasonic “IP Setting Software”, click the [Run] button next to [IP Setting Software] from theCD launcher menu window, or double-click on the shortcut icon created after installing the software on thePC.• The License Agreement will be displayed. Read the Agreement and choose “I accept the terms in thelicense agreement”, and click [OK].2. Click the [Network Settings] button after selecting the MAC address/IP address of the camera to beconfigured.Note• When using a DHCP server, the IP address assigned to the camera can be displayed by clickingthe [Search] button of the “IP Setting Software”.• When a duplicate IP address is used, the corresponding camera number will be displayed shaded.Operating Instructions 22521 Using the CD-ROM
