The description below is the configuration of the priority stream that can transmit images without deterioratingthe image quality and refresh interval even when multiple users access concurrently.Priority stream[Activation]Select “On” or “Off” to determine whether or not to use the priority stream.• Default: OffNote• When “On” is selected for “Activation” of “Priority stream”, number of users who can access the cameramay be limited.[Destination IP address(1)]Enter the first destination IP address.[Destination IP address(2)]Enter the second destination IP address.[Stream type]Select either “JPEG”, “H.264/MPEG-4(1)” or “H.264/MPEG-4(2)”.• JPEG: JPEG images will be transmitted.• H.264/MPEG-4(1): H.264(1) (or MPEG-4(1)) images will be transmitted.• H.264/MPEG-4(2): H.264(2) (or MPEG-4(2)) images will be transmitted.• Default: JPEGNote• When “Best effort” is selected for “Transmission priority” of “H.264 (MPEG-4)”, bit rate will vary betweenthe maximum and minimum rates while images are being transmitted.SW396SW396SW395SW395SC386SC386SC385SC385SC384SC384SW175SW175SW172SW172ST165ST165ST162ST162:• When “H.264” is selected for “Recording format”, it is impossible to transmit H.264(2) images. In thiscase, “H.264/MPEG-4(2)” is invalidated.[Refresh interval*]Select the refresh interval from the following.This setting is validated only when “JPEG” is selected for “Stream type”.SW395SW395SC385SC3850.1fps/ 0.2fps/ 0.33fps/ 0.5fps/ 1fps/ 2fps/ 3fps/ 5fps/ 6fps/ 10fps/ 12fps*/ 15fps*/ 30fps*Operating Instructions 15915 Configure the settings relating to the authentication [User mng.]
