13.2 Configure the settings relating to the cameraaction on alarm occurrence [Alarm]Click the [Alarm] tab on the “Alarm” page. (®page 47, page 49)The settings relating to the camera action at an alarm occurrence can be configured in this section. Refer topages 134, 138 and 141 for further information about the settings relating to the alarm, the alarm image andthe alarm output terminal.Camera action on alarm[Terminal alarm 1]Select an action to be taken when a terminal alarm 1 is detected from the following.• Off: Does not take any action even when a terminal alarm 1 is detected.• 1-64SW395SW395SC385SC385SC384SC384SW175SW175SW174WSW174WSW172SW172ST165ST165ST162ST162 : When the registeredpreset position is selected, the camera will move to the selected preset position when a terminal alarm 1is detected.• Auto trackSW395SW395SC385SC385 : When a terminal alarm 1 is detected, the camera will start the auto tracking.• 1-256SW396SW396SC386SC386 : If a previously registered preset position is selected, when a terminal alarm 1 isdetected, the camera will move to that position.• Auto trackSW396SW396SC386SC386 : When a terminal alarm 1 is detected, the camera will start the auto tracking.• Patrol 1SW396SW396SC386SC386 : When a terminal alarm 1 is detected, the camera will start the patrol.* If Patrol 1 is not registered it is not displayed on the screen.• Default: Off[Terminal alarm 2]Select an action to be taken when a terminal alarm 2 is detected from the following.• Off: Does not take any action even when a terminal alarm 2 is detected.136 Operating Instructions13 Configure the alarm settings [Alarm]
