– OpenSW175SW175SW174WSW174WSW172SW172ST165ST165ST162ST162 : An alarm is detected when the terminal statusis changed to “Off”.• Alarm output: Alarm output will be carried out according to the settings for “Alarm output terminalsetup” (®page 141).• Default: Off[Terminal 3]Determine how to use terminal 3.• Off: Not used.• Alarm input: Receives alarms.– CloseSW175SW175SW174WSW174WSW172SW172ST165ST165ST162ST162 : An alarm is detected when the terminal statusis changed to “On”.– OpenSW175SW175SW174WSW174WSW172SW172ST165ST165ST162ST162 : An alarm is detected when the terminal statusis changed to “Off”.• AUX output: AUX output will be supplied. The [AUX] buttons will be displayed on the “Live” page.• Default: OffNote• AUX is a camera terminal that allows users to operate (Open/Close) arbitrarily from the “Live” page.For example, an operator can remotely control lights in a place where the camera is installed byconnecting the terminal to the light controller.• Refer to the installation guide for further information about input/output rating of each terminal.SW396SW396SW395SW395SC386SC386SC385SC385SC384SC384:• While “Alarm input” is being selected, an alarm is detected when the terminal status is changed to“On”. (Default)It is possible to configure the setting so that an alarm is detected when the terminal status is changedto “Off”. Refer to the [Readme] file on the provided CD-ROM for further information about the setting.Or refer to our website (http://panasonic.net/pss/security/support/info.html) for further informationabout the supported software.[VMD alarm]When clicking “VMD >>”, the [VMD area] tab of the “Alarm” page will be displayed. (®page 143)[Auto track alarm]SW396SW396SC386SC386When clicking “Auto track setting >>”, the [Image/Position] tab of the “Camera” page will be displayed. Thesetup menu will be displayed in a newly opened window. (®page 120)[Command alarm]Select “On” or “Off” to determine whether or not to receive the command alarm.The command alarm is the function that provides notification of a Panasonic protocol alarm from the othercameras. When “On” is selected, alarm actions will be performed between multiple cameras.• Default: Off[Originating port number]Select a port number to be used to receive the command alarm.• Available range: 1-65535• Default: 8181The following port numbers are unavailable since they are already in use.20, 21, 23, 25, 42, 53, 67, 68, 69, 80, 110, 123, 161, 162, 443, 554, 995, 10669, 10670, 59000-61000Operating Instructions 13513 Configure the alarm settings [Alarm]
