• Available number of characters: 0 - 32 characters• Default: None (blank)[Location]Enter the name of the location where the camera is installed.• Available number of characters: 0 - 32 characters• Default: None (blank)[Contact]Enter the mail address or the phone number of the SNMP manager.• Available number of characters: 0 - 255 characters• Default: None (blank)17.6 Configure the settings relating to the FTPperiodic image transmission [FTP img. trans.]Click the [FTP img. trans.] tab on the “Network” page. (®page 47, page 49)The settings relating to the periodic transmission of images to an FTP server can be configured on this page.To transmit images to an FTP server periodically, it is necessary to configure the settings of the FTP server inadvance (®page 162). Refer to page 199 for descriptions of how to configure schedules of imagetransmission.IMPORTANT• Depending on the network line speed or the network traffic, images may not be transmitted at the exactdesignated interval or period.• When “On” is selected for both of the alarm image transmission function and the FTP periodic imagetransmission function, the alarm image transmission function will be given priority over the FTP periodicimage transmission function. For this reason, images may not be transmitted at the exact designatedinterval or period if alarms occur frequently.SW396SW396SW395SW395SC386SC386SC385SC385SC384SC384SW175SW175SW172SW172ST165ST165ST162ST162:• Select “FTP error” for “Save trigger” on the [SD memory card] tab when using the FTP periodictransmission function.NoteSW396SW396SW395SW395SC386SC386SC385SC385SC384SC384SW175SW175SW172SW172ST165ST165ST162ST162:Operating Instructions 19717 Configuring the network settings [Network]
