In advance, install the root certificate and intermediate certificate on the browser in use. Follow theinstructions of CA for how to obtain and install these certificates.• When the camera is accessed using the HTTPS protocol, the refresh interval and frame rate of imagesmay be lower.• When the camera is accessed using the HTTPS protocol, it may take time to display images.• When the camera is accessed using the HTTPS protocol, the images may be distorted or audio maybe interrupted.• When the camera is accessed using the HTTPS protocol, the number of users that can access thecamera may be reduced. The maximum number of concurrent access user varies depending on themaximum image size and transmission format.17.3 Access the camera using the HTTPS protocolNote• SW395R, SC385R, and SC384R do not support the HTTPS function.1. Start up the web browser.2. Enter the IP address of the camera in the address box of the browser.• Example of entry: https://192.168.0.10/IMPORTANT• When the HTTPS port number is changed from “443”, enter “https://IP address of the camera + :(colon) + port number” in the address box of the browser.(Example: https://192.168.0.11:61443)• When the camera is in a local network, configure the proxy server setting of the web browser (under[Internet Options...] under [Tools] of the menu bar) to bypass the proxy server for the local address.3. Press the [Enter] key on the keyboard.→ The “Live” page will be displayed.When the security alert window is displayed, install the security certificate. (®page 182 - page 188)When “On” is selected for “User auth.”, the authentication window will be displayed before displayinglive images for the user name and password entries.IMPORTANT• When the camera is accessed using the HTTPS protocol, the refresh interval and frame rate ofimages may be lower.17.3.1 Install the security certificateWhen the security certificate of the camera to access is not installed on the PC, the security alert window willbe displayed each time the camera is accessed using the HTTPS protocol. To have the security alert windownot displayed, it is necessary to install the security certificate in the following procedure. If the certificate is notinstalled, the alert window will be displayed each time the camera is accessed.Note• The security certificate is installed on the PC with the information registered for “Common Name”.Therefore, the information registered for “Common Name” must be same as the address or host namefor the camera access. If the certificate is not the same, the security alert window will be displayedeach time the camera is accessed.• When the address or host name of the camera is changed, the security alert window will be displayedeach time the camera is accessed even if the security certificate is installed. Install the securitycertificate again.Operating Instructions 18117 Configuring the network settings [Network]
