20.4 Reset the settings/Reboot the camera [Defaultreset]Click the [Default reset] tab of the “Maintenance” page. (®page 47, page 49)The settings and the HTML data of the camera can be initialized and reboot of the camera can be performedon this page.[Reset to the default (Except the network settings)]Click the [Execute] button to reset the settings to the default. Note that the network, wireless, and preset positionsettings will not be reset.It is impossible to operate the camera for about 3 minutes after the initialization.[Load the default HTML files (setup menu).]Click the [Execute] button to reset the HTML files to the default.It is impossible to operate the camera for about 3 minutes after the initialization.[Reset to the default and load the default HTML files.]Click the [Execute] button to reset the settings of the camera and the HTML files to the default. Note that thenetwork, wireless, and preset position settings will not be reset.It is impossible to operate the camera for about 3 minutes after the initialization.[Reboot]Click the [Execute] button to reboot the camera. It is impossible to operate the camera for about 2 minutesafter rebooting the camera.[Position refresh]SW396SW396SW395SW395SC386SC386SC385SC385SC384SC384The camera position can be refreshed. When the camera has moved from the correct home/preset positionduring normal use, or when it has been inadvertently moved while turning on the power of the camera, usethis function to correct the camera position.It is impossible to operate the camera during the position refresh process (for about 2 minutes).IMPORTANT• The direction of the camera may be accidentally changed when the camera is installed. Whenregistering presets after the installation, we recommend performing position refresh.Note•SW396SW396 :To initialize the network settings (®page 166), turn off the power of the camera, then turn on the poweragain while holding down the [INITIAL SET] switch on the unit, and keep the [INITIAL SET] switch helddown for about 5 seconds. Wait about 6 minutes after releasing the button. The camera will start up220 Operating Instructions20 Maintenance of the camera [Maintenance]
