Note• Panning, tilting and zooming operations can also be carried out on the [Image/Position] tab.• Adjusted zoom and focus position for the auto pan function will be applied when [Set] button of “Startposition” is clicked.[End position]SW395SW395SC385SC385SC384SC384Move the camera to the desired point to be set as the end point of the auto panning using the control pad/buttons, and then click the [Set] button to register the position as the end position.Auto pan[Dwell time]Select a dwell time at the start point and the end point from the following.5s/ 10s/ 20s/ 30s• Default: 5s[Speed]Select a speed for the auto panning from the following.3°/s, 4°/s, 5°/s, 7°/s, 10°/s, 13°/s, 18°/s, 24°/s• Default: 13°/sIMPORTANT• When “Dwell time” or “Speed” is edited, it is necessary to click the [Set] button to apply them.Note• Even when the selected zoom factor is higher than 36xSW395SW395SC385SC385SC384SC384 /72xSW396SW396SC386SC386, the camera will start panning with 36xSW395SW395SC385SC385SC384SC384 /72xSW396SW396SC386SC386zoom factor.[Endless panning]SW396SW396SC386SC386The operations for panning can be set to the followingOff: Pan between the left and right end position points.On(Clockwise): Pans clockwise.On(Counterclockwise): Pans counterclockwise.Default: Off[Zoom] buttons, [Focus] buttons, [Brightness] buttons, Control pad/buttons and [Go] buttonRefer to page 12 for descriptions of how to operate these buttons/pad.[Close] buttonClick this button to close the “Auto pan” setup menu.11.6.6 Configure the settings relating to patrol (“Patrol” setupmenu) (SW396/SC386)Click the [Setup>>] button of “Patrol” on the [Image/Position] tab of the “Image/Audio” page (®page 98).118 Operating Instructions11 Configure the settings relating to images and audio [Image/Audio]
