Panasonic WJ-DR200 Operating Instructions Manual

Also see for WJDR200 - DIGITAL VIDEO RECORD: Operating instructions User guide

Panasonic WJ-DR200 Operating Instructions Manual Manual pdf 38 page image

-36-RECORDING Recording ModesThe WJ-DR200 Disc Recorder has three recordingmodes to match your specific needs.Refer to the Recording Mode Menu on page 19 for mak-ing the necessary settings.Single Shot Recording: Records one freeze picture inresponse to a command or signal input.Multi Shot Recording: Records multiple freeze picturesin response to a command or signal input.Time Lapse Recording: In Manual Recording, recordsa continuous series of freeze pictures at a specifiedinterval until the STOP button is pressed.In Alarm Recording, records a continuous series offreeze pictures at a specified interval for the dura-tion of alarm input. Manual RecordingThe following procedure describes how to record manu-ally in the selected mode.Caution: Confirm that the ALARM REC indicator is notlit on the front panel of the recorder.If the indicator is lit, turn it off by pressing theALARM REC STANDBY button on the control panelof the recorder. Manual Record1. Press the REC button.5REC is displayed in the lower center of the monitorscreen, and recording in the selected mode starts.REC012345aS RECAUG 1.98 14:15:05 100%2. To stop recording, press the STOP button.PAUSE REC012345aS RECAUG 1.98 14:15:05 100% Manual Record with Standby1. Press the REC button while holding down thePAUSE button.yREC is displayed in the lower center of the monitorscreen, and the recorder stands by for recording inthe selected mode.2. Press the REC button.5REC is displayed in the lower center of the monitorscreen, and recording in the selected mode starts.3. When recording is completed, the recorder auto-matically goes into standby mode.yREC is displayed in the lower center of the monitorscreen.4. Press the REC button again to record the next shot.5. To stop recording, press the STOP button. Alarm RecordingThe following procedure describes automatic recordingof alarm input in the selected mode.Refer to the Alarm Recording Menu on page 26 fordetails.1. Press the ALARM REC STANDBY button on thecontrol panel of the recorder.Confirm that the ALARM REC indicator on the frontpanel of the recorder is lit.Note: If the ALARM REC indicator is not lit, pressthe ALARM REC STANDBY button again.2. Recording will start automatically in the selectedmode when an alarm or sensor input is received.Recording will end automatically after the specifiednumber of frames have been recorded or the speci-fied time has elapsed.Notes:• When a sensor input is received, the ALARMindicator, buzzer and alarm output are not acti-vated.• A different recording pattern and number offrames can be set for alarm and sensor input.