Panasonic WJ-DR200 Operating Instructions Manual

Also see for WJDR200 - DIGITAL VIDEO RECORD: Operating instructions User guide

Panasonic WJ-DR200 Operating Instructions Manual Manual pdf 49 page image

V OH = 11 - 13 V (4 700 Ω)V OL = 0 - 0.6 V (3.0 mA max.)V OH = 5±0.5 V (200 Ω)V OL = 0 - 0.6 V (3.0 mA max.)AlarmRecoverOutput-47-GeneralPower Source: 120 V AC, 60 HzPower Consumption: 38 WAmbient Operating Temperature: +5°C - +40°C (41°F - 104°F)Ambient Operating Humidity: Less than 90 %Dimensions: 420 (W) x 88 (H) x 350 (D) mm16-9/16” (W) x 3-7/16” (H) x 13-3/4” (D)Weight: 7 kg (15.4 lbs.)Input and OutputVideo Input A: 1.0 V[p-p]/75 Ω NTSC Composite Video Signalwith 75 Ω Automatic Termination/Looping through (x1)Y Signal; 0.714 V[p-p], C Signal; 0.286 V[p-p]/75 Ω S-Video Signal (x1)Video Input B: 1.0 V[p-p]/75 Ω NTSC Composite Video Signalwith 75 Ω Automatic Termination/Looping through (x1)Video Output: 1.0 V[p-p]/75 Ω NTSC Composite Video Signal (x1)Y Signal; 0.714 V[p-p], C Signal; 0.286 V[p-p]/75 Ω S-Video Signal (x1)Audio Input: 47 kΩ unbalanced, RCA standard jack, 11 kHz samplingAudio Output: 600 Ω unbalanced, RCA standard jackCamera Switching Output: 1 circuit, RCA standard jackTerminal Board: Sensor Input: Pulse width 100 ms or more, Normally open or normally closedselectableAlarm Input: Pulse width 100 ms or more, Normally open or normally colosedselectableAlarm Reset Input: Pulse width 100 ms or more, Low activeSeries Record Input: 1 circuitTime Adjustment Input: Pulse width 100 ms or more, Low activeAlarm Output: Switched by alarm output level selector*1Alarm Recover Output: Switched by alarm output level selector, Pulse width 100ms* 1LED Monitor Output: 1 circuit (ALARM REC, REC, DISC), 30 V DC 50 mA max.Buzzer Output: 30 V DC 50 mA max.System Error Output: 30V DC 50 mA max.Thermal Error Output: 30 V DC 50 mA max.Time Adjustment Output: Pulse width 1 s, 30V DC 50 mA max.Series Record Output: 30 V DC 50 mA max.Serial Control Port: Baud Rate; 2 400 - 115 200 bps, Data Bit: 8, Parity Check: None, Start Bit: 1, StopBit: 1, (25-pin D-sub Connector)Parallel Control: (25-pin D-sub Connector)*1 Alarm Output Level Selector [H]SPECIFICATIONSWeight and dimensions shown are approximate.Specifications are subject to change without notice.AlarmOutputV OLV OHAlarmAlarm Output Level Selector [L], 30 V DC 50 mA max.

/ 51

Related manuals for Panasonic WJDR200 - DIGITAL VIDEO RECORD