Panasonic WJ-DR200 Operating Instructions Manual

Also see for WJDR200 - DIGITAL VIDEO RECORD: Operating instructions User guide

Panasonic WJ-DR200 Operating Instructions Manual Manual pdf 24 page image

-22-2. Select either pattern by pressing the or but-ton.SAME AS ALARM: Same recording pattern asfor alarm activationDIFF FROM ALARM: Different recording patternthan for alarm activationThe default setting is SAME AS ALARM.3. If you select DIFF FROM ALARM in step 2 above,you need to change the following parameters.• Pre/Post-FramesThis item lets you select the number of pre andpost-frames recorded when there is sensor inputfrom the SENSOR IN terminal.The maximum number of pre and post-frames is setwith the PRE/POST FRAMES parameter above.1. Move the cursor to the PRE/POST FRAMESparameter in the MULTI SHOT menu by press-ing the or button.2. Select the number of pre and post-frames to berecorded by pressing the or button.• Post-Frame Recording PatternThis item is available only if the CAMERA INPUTparameter in the VIDEO INPUT menu is set to A+B(CAMERA ID OFF).It lets you select recording of pre and post-framesfrom input A and/or B when there is sensor inputfrom the SENSOR IN terminal.1. Move the cursor to the POST REC PATTERN para-meter in the MULTI SHOT menu by pressing theor button.2. Select the desired recording input for post-framesby pressing the or button.AA: Records input A for post-frames.BB: Records input B for post-frames.AB: Records input A and B for post-frames.2. Time Lapse Recording MenuThis menu lets you set up the details for Time LapseRecording.Note: Manual Alarm Recording, Record Partition andAuto Start are not available in MODE 2.1. Move the cursor to the CAPTURE MODE parameterin the REC MODE menu by pressing the orbutton. Pre/Post FramesThis item lets you specify the number of pre-frames.A pre-frame is a frame recorded during standby formanual recording or prior to input of the alarm signal inalarm recording.A post-frame is a frame recorded after the REC buttonwas pressed in manual recording or after input of thealarm signal in alarm recording.1. Move the cursor to the PRE/POST FRAMES para-meter in the MULTI SHOT menu by pressing theor button.2. Select the desired number of pre-frames by press-ing the or button.Subtracting the number of pre-frames from this totalgives you the number of recorded post-frames.The default setting is 0. Recording PatternWhen the CAMERA INPUT parameter in the VIDEOINPUT menu is set to A+B (CAMERA ID OFF), this itemlets you select recording of pre and post-frames frominput A and/or B.1. Move the cursor to the REC PATTERN parameter inthe MULTI SHOT menu by pressing the orbutton.2. Select the desired recording input by pressing theor button as shown below.Pre FrameQuantityZeroAAABBB–––AA and BBAA/BBAA/ABBB/AABB/ABAB/AAAB/BBAB/ABMore thenoneAABBA and BA and BA and BBA and BAA and BABA and BPre FrameRecordedPost FrameRecordedParameter Sensor RecordingThis item lets you select whether to record sensor inputfrom the SENSOR IN terminal on the rear of the DiscRecorder according to the same pattern as set for alarmrecording or according to a different pattern.1. Move the cursor to the SENSOR REC parameter inthe MULTI SHOT menu by pressing the orbutton.