Panasonic WJ-DR200 Operating Instructions Manual

Also see for WJDR200 - DIGITAL VIDEO RECORD: Operating instructions User guide

Panasonic WJ-DR200 Operating Instructions Manual Manual pdf 32 page image

-30-MAINSET UP ENABLESYSTEM *REC MODE MODE1 *MODE2 *ALARM RECORD *SEARCH/PLAY *SYSTEM INFO *Panasonic AV Disc Recorder V1.0R00Move the cursor to SYSTEM INFO in the MAIN menu bypressing the or button, then press the SET but-ton. The SYSTEM INFO menu shown below appears onthe monitor screen.SYSTEM INFODRIVE SLEEP ONMEDIUM INFO NO DISCVOLUME LABEL - -SET_UP PASSWORD - -FACTORY USEDIAG INFO (00- 0- 0 0:00)FM CON -- JPEG --SCSI CON -- AUDIO --VIDEO DEC -- SERIAL I/O --DRAM -- DVD DRIVE --SRAM -- PD-2 LD-D100 MSTRM CON -- Drive Condition SetupThis item lets you specify whether to deactivate the DVDdrive when no operation takes place for a certain time orkeep it active.1. Move the cursor to the DRIVE SLEEP parameter inthe SYSTEM INFO menu by pressing the orbutton.2. Select either ON or OFF by pressing the orbutton.ON: Deactivates the DVD drive automatically after30 minutes when no operation takes place.OFF: Keeps the DVD drive activated continuously.The default setting is ON.Notes:• If you record alarms frequently, for example, atintervals of a few seconds, it is recommended toselect OFF position.• Also select OFF position to avoid that someframes are omitted from recording when startingTime Lapse Recording at high capture rate afterthe DVD drive has been deactivated. System Information MenuThis menu allows you to specify the sleep operationmode of the DVD drive and lists status information forthe Disc Recorder.2. Move the cursor to ALARM LABEL (or SENSORLABEL) in the ALARM RECORD menu by pressingthe or button then press the SET button.The label editing menu shown below appears.A B C D E F G H I J KL M N O P Q R S T U VW X Y Za b c d e f g h i j kl m n o p q r s t u vw x y z1 2 3 4 5 6 7 8 9 0 _( ) . , ’ ” : ; & # !? = + - * / % $CLEAR(SET)ALARM RECORDSIGNAL TYPE CLOSE ↓ALARMRECOVER FUNCTION TIMERTIMER DURATION 2 secBUZZER OFFLABEL *SENSORLABEL *DELAY TIME 0.05 secPROGRAM TIMER OFFAll items other than those described above pro-vide information on the Disc Recorder’s systemstatus and cannot be changed from this menu. Label SetupThe Disc Recorder can display the point of origin of anyincoming alarm or sensor signal on the monitor screen.This is done by assigning three types of labels consist-ing of up to 8 characters.ALARM LABEL: Label assigned to the frame coin-ciding with alarm input and all fol-lowing frames.SENSOR LABEL: Label assigned to the framecoinciding with sensor input andall following frames.VOLUME LABEL: Label assigned to a DVD-RAMdisc. Alarm / Sensor Label Setup1. Move the cursor to ALARM RECORD in the MAINmenu by pressing the or button, then pressthe SET button. The ALARM RECORD menu shownbelow appears on the monitor screen.