Panasonic WJ-DR200 Operating Instructions Manual

Also see for WJDR200 - DIGITAL VIDEO RECORD: Operating instructions User guide

Panasonic WJ-DR200 Operating Instructions Manual Manual pdf 10 page image

WJ-DR200 Setup MenuVIDEO INPUT-8-SYSTEM CONNECTIONS Basic SystemShown below is a typical connection scenario.CAUTION - FOR CONTINUED PROTECTIONManufactured by Matushita CommunicationI n d u s t r i a l C o . L t d Y o k o h a m a J a p a n- AFIN D' ASSURER UNEATTENTIONAGAINST FIRE HAZARD REPLACE ONLY WITHSAME TYPE FUSEPROTECTION PERMANENTE CONTRE LES RISQUESD' INCENDIE REPLACER UNIQUEMENT PAR UNFUSIBLE DE MEME TYPEPOWER 120V AC 60 Hz 38WVIDEO OUT 1V [ p-p ] 75ΩFOR COMMERCIAL USE ONLY Made In JapanSIGNAL GND 120V AC 60HzOFF125V 4 APOWERONGNDSENSOR INALARM INALARM RESET INSERIES REC INTIME ADJUST INGNDALARM OUTALARM RECOVER OUTALARM RECRECDISCBUZZER OUTSYSTEM ERROR OUTTHERMAL ERROR OUTTIME ADJUST OUTSERIES REC OUTLEDMONITORCAMERA SW OUTAUDIOPARALELL CONTROLSERIAL CONTROLINOUTS-VIDEOOUTS-VIDEOVIDEO OUTVIDEO INB ASER.NO. 6ZA00001OUTPUT LEVELHLCameraVideo Monitor(Alarm)(Sensor)(VIDEO OUT) (VIDEO IN)WJ-DR200Requirements for alarm and sensor input are as follows:• Open collector output or no-voltage make contact• The voltage between Ground and Alarm Input or Sensor Input when the circuit closes must be 0 to 0.2 V. The polaritiescan be changed by setting the SIGNAL TYPE parameter in the Alarm Recording menu.Notes:• Recording of freeze pictures from VCR playback is not provided as a function. Recording is possible, but the resultsmay not be satisfactory depending on the type of VCR used.• When the Disc Recorder is connected to several cameras, for example through a multiplexer, all camera inputs must besynchronized to obtain proper images.Refer all connection work to qualified service personnel or system installers.• If you use the WJ-DR200 AV Disc Recorder with a Sequential Switcher that is connected to non-synchronized cameras(*1) and switches their video output sequentially (*2), recording with the following capture rates is not available:720 * 480 mode 0.07 sec.720 * 240 mode 0.03 sec.*1: Including cameras with VD (Vertical Drive) synchronization.*2: Without using the camera switching pulse supplied by the WJ-DR200. Connection with Video MultiplexerExample: Connection with Video Multiplexer WJ-FS616Note: Refer connection with a Video Multiplexer other than the WJ-FS616 to qualified service personnel or system installers.MULTI SHOT (MODE *)TIME LAPSE (MODE *)MANUAL REC ALARMSERIAL SETUPItemVIDEO INPUTCAPTURE RATECAMERA INPUTSIGNAL TYPEParameterCOMPOSITE *10.1 sec. or moreA (CAMERA ID ON)RS-232C (VCR mode) *3Default SettingCOMPOSITES *1 COMPOSITE0.20 sec.A (CAMERA ID OFF)RS-232C WJ-DR200 System SetupCautions:Noise may appear in the monitor image and the audio may be interrupted under the following circumstances:• Faulty camera synchronization, causing large frequency deviations between individual cameras• Picture experiencing abrupt changes in brightness• Faulty timing in switching input and recording of video signals (for example, a sequential switcher is not used for thecamera switching output of the disc recorder, or switching is out of synchronization due to an alarm condition)