Section 6: Clarius Model 4200A-SCS Parameter Analyzer Reference Manual6-308 4200A-901-01 Rev. C / February 2017flashulib user libraryThe flashulib user library contains user modules for flash memory testing. The next table lists andbriefly describes the user modules.flashulib user modulesUser module Descriptionconfigure_dc_flash Disconnects pulse channels by opening the solid-state relay for eachpulse channel in the supplied list. This routine should be used beforerunning a DC test when the pulse and DC signals are connected at eachDUT terminal.double_pulse_flash Defines and outputs 1 to 8 waveforms that consist of two pulses that haveindepedent widths and levels. The waveforms are defined using linesegments (Segment Arb mode). You can define the waveform for just aprogram or erase pulse or for a waveform that combines program anderase cycles for up to eight independent pulse channels.pmu_configure_dc_flash Disconnects pulse channels by opening the solid-state relay for eachpulse channel in the supplied list. This routine should be used beforerunning a DC test, when the pulse and DC signals are connected togetherat each DUT terminal.pmu_double_pulse_flash Defines and outputs 1 to 8 waveforms that consist of two pulses that haveindepedent widths and levels. The waveforms are defined using linesegments (Segment Arb mode of the 4220-PGU or 4225-PMU). You candefine the waveform for just a program or erase pulse or for a waveformthat combines both program and erase cycles for up to eight independentpulse channels.pmu_single_pulse_flash Defines and outputs 1 to 8 waveforms that consists of two pulses thathave indepedent widths and levels. The waveforms are defined using linesegments (Segment Arb mode of the 4220-PGU or 4225-PMU). You candefine the waveform for just a program or erase pulse or for a waveformthat combines both program and erase cycles for up to eight independentpulse channels.single_pulse_flash Defines and outputs 1 to 8 waveforms that consist of two pulses that haveindepedent widths and levels. The waveforms are defined using linesegments (Segment Arb mode of the pulse card). You can define thewavform for just a program or erase pulse or for a waveform thatcombines both program and erase cycles for up to eight independentpulse channels.
