Section 5: Pulse measure and pulse generator units Model 4200A-SCS Parameter Analyzer Reference Manual5-16 4200A-901-01 Rev. C / February 2017Connections to prober or test fixture bulkhead connectorsThe 4200-PMU-Prober-Kit (available from Keithley Instruments) is a collection of standard andcustom connectors and accessories used to connect the pulse generator to a common variety ofprobe stations. This kit can also be used for pulse card connections to a test fixture.The next figure shows an example of how a PMU or PGU can be connected to a triaxial connector ofa prober or test fixture.If connecting to a prober or test fixture that uses BNC connectors, adapter C is not used.Figure 154: Pulse card connections to triax prober or test fixtureA. White SMA cable (2 m/6.5 ft, included with the PGU and PMU)B. SMA female-to-BNC male (included with the 4200-Prober-Kit)C. BNC female-to-three-lug triax male (included with the 4200-Prober-Kit))Using an SMA to SSMC adapter cable to connect pulse card to DUTThe next figure shows an example of how to make pulse card connections to the device under test(DUT) using the supplied adapter cable.Figure 155: Pulse card connections using the SMA to dual SSMC adapter cableA. White SMA cable (2 meters / 6.5 feet, included with the PGU and PMU)B. SMA to SSMC Adapter Cable (4200-PRB-C, included with the PGU and PMU)The needle holders shown in the previous figure are supplied by the user.
