Model 4200A-SCS Parameter Analyzer Reference Manual Section 6: Clarius4200A-901-01 Rev. C / February 2017 6-11Add a device and test to the projectYou can add additional items to a project. Once a project is added from the library to the project tree,it is copied from the project in the library, so you can make changes without affecting the originalproject. The project in the project tree is is stored in My Projects.This example shows you how to add a predefined test to the project. Predefined tests are configuredwith commonly used parameter settings and a set of typical data. Once they are in a project, you canchange the parameters as needed. They can be an efficient way for you to add a test to your project.You can use the basic procedure described here to find any items in the library.To add a four-terminal MOSFET device and test to the project:1. Change the library to Tests.2. In the Filters pane, select Transistor and 4 Terminals.3. In the search box, type MOSFET and select Search.4. Scroll to the MOSFET Drain Family of Curves (vds-id) test.5. Select Add. The selected test and the device is added to the project tree under the previous itemthat was highlighted.6. To move the device and test, drag the device to a new location.7. Select Save.Figure 218: Add a MOSFET test and device to the projectIf the device for a test is not in the project tree, Clarius adds the appropriate device when you add atest to the project tree. You can also add the device and test separately.
