Gain56GainDepending on the shooting conditions, you may want to adjust the brightness of the image. You can do so bychanging the gain value to adjust the sensitivity of the sensor. The camcorder offers 3 gain levels (L/M/H) thatyou can adjust in advance (gain value and increment) and select simply by changing the position of a switch. Youcan also select automatic gain control and even set a limit for the maximum gain value used (AGC limit).You can also perform this function remotely using Browser Remote on a connected network device (A 162,168).Available gain settings* > [v " Camera Setup] > [Gain L]/[Gain M]/[Gain H] > [Mode] setting.**The available range will vary depending on the [Gamma] setting in the custom picture file (A 124).[Wide DR], [Canon Log 3]: 2.5 dB to 33.0 dB[PQ]: –2.0 dB to 33.0 dB[HLG]: –2.5 dB to 33.0 dBAutomatic Gain ControlSet the AGC switch to ON.• The camcorder will adjust the gain automatically to obtain anappropriate exposure.• The gain value set automatically by the camcorder willappear at the bottom of the screen with an icon next to it.AGC LimitWhen the camcorder is set to automatic gain control (AGC),you can set a limit for the maximum gain value that can be setautomatically. When the camcorder is set to full auto mode(A 43) or infrared recording is activated (A 116), the AGClimit will not apply (it will be set to [Off/33 dB]).1 Select [AGC Limit].> [v " Camera Setup] > [AGC Limit]2 Select the desired gain level and then press SET.NOTESNOTES• You can use the > [v ! Camera Setup] > [AE Response] setting to change how quickly theexposure is adjusted when the camcorder is set to automatic gain control (AGC).Operating modes:Gain mode* Available range[Normal] (3-dB increments) – 6.0 dB to 33.0 dB**[Fine] (0.5-dB increments)
