Selecting a Network Connection160Selecting a Network ConnectionYou can save up to 4 network configuration profiles. If you just saved a new network configuration, it will alreadybe automatically selected so follow this procedure to select a different configuration profile.1 Select [Connection Settings].> [ ! Network Settings] > [Connection Settings]2 Select the desired configuration number and then press SET.3 Select [OK] and then press SET.Checking the Network’s StatusAfter activating a network function, the camcorder will connect to the network that was configured in advance.The icons displayed on the screen will indicate the type of network selected and the connection status.Wi-Fi (Infrastructure):In yellow – the camcorder is connecting to or disconnecting from the network. In white – thenetwork function can be used.Wi-Fi (Camera Access Point):In yellow – starting the camcorder’s access point. In white – the camcorder’s access point isready. Connect the Wi-Fi enabled device to the camcorder.Ethernet: In yellow – the camcorder is connecting to or disconnecting from the network. In white – thenetwork function can be used.The (Ethernet) indicator next to the terminal will flash or illuminate as follows*: Flashing ingreen – connecting to the network or streaming video (IP streaming only); illuminated in green –FTP transfer active; flashing in red – network error.: Browser Remote (A 162): IP streaming (A 173): FTP transfer (A 176)* You can also set > [B $ System Setup] > [LED] > [ (Ethernet)] to [Off] to disable the indicator.
