155Connecting to a Wi-Fi NetworkCamera Access PointIn this mode the camcorder itself serves as a wireless access point to which other Wi-Fi-enabled devices canconnect. Initially, basic settings for a Camera Access Point connection (network name (SSID):[XF705-xxxx_Canon0C], password: [12345678]) are already saved under network configuration profile [1:]. Youcan use the default settings to connect immediately to the camcorder or follow the procedure below if you wishto change the settings.1 Select [Connection Settings].> [ ! Network Settings] > [Connection Settings]2 Select the desired network configuration profile and then select [Camera Access Point].Network configuration profile ([1:] to [4:]) > [Edit] > [Camera Access Point]• You can save up to 4 network configuration profiles in the camcorder. Push the joystick up/down to selectthe desired profile.3 Enter the SSID (network name) the camcorder will use as a Wi-Fi access point.[Input] > Enter the desired network name using the keyboard screen (A 27) > [OK]4 Select the frequency band for the Wi-Fi connection ([5 GHz] or [2.4 GHz]) and then press SET.• For users of model ID0118 PAL (A 17): Because only the 2.4 GHz frequency band is available for CameraAccess Point mode, skip to step 5.5 Select the channel and then press SET.• Available channels will differ depending on the selected frequency band. (Not applicable depending on themodel.)6 Select the encryption method and then press SET.• If you selected [Open/No encryption], skip to step 8.7 Enter the encryption key (password).[Input] > Enter the desired password using the keyboard screen (A 27) > [OK]• This password is needed to connect the network device to the camcorder. If necessary, write it down.8 Continue with the procedure to configure the IP address assignment (A 155).Configuring the IP Address SettingsAt this point you need to configure the TCP/IP settings. If you need to configure the TCP/IP settings manually,consult the network administrator to obtain the relevant information.1 Select the method for assigning the IP address ([Automatic] or [Manual]) and then press SET.• If you selected [Automatic], the IP address will be assigned automatically. Continue with the procedure toreview and save the configuration (A 156).2 Enter the IP address.• Push the joystick up/down to select a value for the first field and then press SET to move to the next field. Aftercompleting the four fields of the address, select [Set] and then press SET.3 Enter the rest of the necessary TCP/IP settings in the same way.• Camera Access Point connections: Enter the [Subnet Mask].• Infrastructure/Ethernet connections: Enter the [Subnet Mask], [Default Gateway], [Primary DNS Server] and[Secndry DNS Server]. If necessary, touch [Í]/[Î] to scroll up/down.4 After completing the necessary settings, continue with the procedure to review and save the configuration(A 156).
