149Applying a LUT to Screens/Video OutputsAdjusting the Color Quality for HLG OutputYou can change the quality of the color reproduction when the [HLG : BT.2020] LUT is used.1 Select [HLG Color].> [¢ # Monitoring Setup] > [HLG Color]2 Select the desired setting and then press SET.Options[BT.2100]: Color reproduction according to ITU-R BT.2100 specifications.[Vivid]: More saturated color reproduction according to the 'Traditional Colour' approach in ITU-RBT.2390.Adjusting the Gain Difference between HDR and SDRWhen a LUT that allows gain adjustment is selected, you can adjust the difference in gain between the SDRoutput relative to the HDR image.1 Select [Gain for HDRSDR Conv.].> [¢ # Monitoring Setup] > [Gain for HDRSDR Conv.]2 Select the desired setting and then press SET.Selecting the Output RangeYou can select the output range for video output from the SDI terminal or HDMI OUT terminal.1 Select the range setting according to the terminal you want to use.> [¢ # Monitoring Setup] > [Range: SDI] (SDI terminal) or [Range: HDMI] (HDMI OUT terminal)2 Select [During Canon Log 3 Output] or [During HDR Output] and then press SET.3 Select the desired option and then press SET.• Repeat the procedure as necessary to select the output range for other terminals/video outputs.Options[Full Range]: Video output in full range. Available only for the SDI terminal.[Full Range Priority]:Priority will be given to output video in full range whenever possible. Available only for the HDMIOUT terminal.[Narrow Range]:Video output in narrow range (video range).NOTES• If you activate slow motion recording while a LUT was set to [PQ : BT.2020] or [HLG : BT.2020], the LUT will bereset to [Off].• If you set an assignable button to [LUT] (A 117), you can press the button to turn on and off the LUTs appliedto all screens/output terminals at once.• If you change the [Preset] or [Gamma] setting in the custom picture file, the LUTs applied to all screens/outputterminals will be reset to [Off].
