Connecting to a Wi-Fi Network158Manual SetupIf you prefer, you can enter manually the details of the Wi-Fi network you want to connect to. Follow theinstructions on the screen to complete the procedure.1 Enter the access point's SSID (network name).[Input] > Enter the network name using the keyboard screen (A 27) > [OK]2 Select the authentication method and then press SET.• If you selected [Open], select [WEP], press SET and continue the procedure, or select [No Encryption], pressSET and continue with the procedure to configure the IP address assignment (A 155).3 Select the WEP index or encryption method, depending on the selected authentication mode.• [Shared Key]/[WEP]: Select the WEP index and then press SET.• [WPA-PSK]/[WPA2-PSK]: Select [TKIP] or [AES] and then press SET.4 Enter the encryption key (password).[Input] > Enter the password using the keyboard screen (A 27) > [OK]5 Continue with the procedure to configure the IP address assignment (A 155).NOTESValid passwords vary depending on the encryption method.64-bit WEP encryption: 5 ASCII characters or 10 hexadecimal characters.128-bit WEP encryption: 13 ASCII characters or 26 hexadecimal characters.AES / TKIP encryption: 8 to 63 ASCII characters or 64 hexadecimal characters.* Note: ASCII characters include the numbers 0 to 9, the letters a to z and A to Z and some punctuation marks and specialsymbols. Hexadecimal characters comprise the numbers 0 to 9 and the letters a to f and A to F.
